Development and implementation of an electronic prototype for solar panel characterization on exterior conditions

Authors

  • Juan Bernardo Cano Grupo en Manejo Eficiente de la energía, GIMEL.
  • Jaime Valencia Grupo en Manejo Eficiente de la energía, GIMEL
  • Franklin Jaramillo Centro de Investigación, Innovación y Desarrollo de Materiales-CIDEMAT. Universidad de Antioquia UdeA; Calle 70 No. 52-21
  • Esteban Velilla Grupo en Manejo Eficiente de la energía, GIMEL

Keywords:

solar panels, V-I curve, electronic prototype, diode model, irradiance

Abstract

An electronic prototype was developed and implemented with the aim to evaluate solar panel performance on outdoor condition. The prototype obtains the panel IV-curve by charging a capacitive circuit. Voltage and
current signal acquisition was achieved using a National Instruments card (NI-DAQ-USB6009), controlled by
Labview software. The diode model was used to fit acquired signals in order to reduce electrical noise. The
prototype results were validated with AMPROBE SOLAR600 analyzer using tree different panels in situ (two of 10W with similar characteristics and other of 55W). In uniform irradiance conditions, both devices showed similar performance on the IV curve, open circuit voltage and short circuit current measurements. However, the prototype presented shorter acquisition time and lower sensibility at transient irradiance variations caused
by clouds.

Article Metrics

 Abstract: 1000  PDF (Español (España)): 731 

References

OsterwaldCarl. Standards, Calibration, and Testing of PV Modules and Solar Cells. En: Practical Handbook of Photovoltaics.2012 Elsevier Ltd. 1045-1064.

NREL. National Renewable Energy Laboratory. Standards for PV Modules and Components – Recent Developments and Challenges. September 24-28, 2012. From: http://www.nrel.gov/docs/fy13osti/56531.pdf

Standard IEC 60904-1, Photovoltaic Devices, Part 1: Measurement of Photovoltaic Current–Voltage Characteristics, International Electrotechnical Commission, Geneva, Switzerland. Ed 2. 2006.

Standard IEC 60904-9, Photovoltaic devices – Part 9: Solar simulator performance. International Electrotechnical Commission, Geneva, Switzerland. Ed 2. 2006.

NREL. National Renewable Energy Laboratory. Uncertainty Analysis of Certified Photovoltaic Measurements at the National Renewable Energy Laboratory.Technical Report NREL/TP-520-45299 August 2009. From http://www.nrel.gov/docs/fy09osti/45299.pdf

International Electrotechnical Commission, IEC 60891. Procedures for temperature and irradiance corrections to measured I-V characteristics of crystalline silicon photovoltaic devices. Ed 2. 2009

IEC 61215, Crystalline silicon terrestrial photovoltaic (PV) modules—designqualification and type approval, Ed. 2, 2005.

IEC 61646, Thin-film terrestrial photovoltaic (PV) modules—design qualification and type approval, Ed. 2, 2008.

IEC 62108, Concentrator photovoltaic (CPV) modules and assemblies—design qualification and type approval, Ed. 1, 2007.

European Commission Joint Research Centre, Guidelines for PV Power measurement in Industry. Disponible en: http://publications.jrc.ec.europa.eu/repository/bitstream/JRC57794/eur-24359-en.pdf

[consultado el 21 de agosto de 2015].

EPRI 2014. Journal Beyond Speculation and Sci-Fi: Researchers Help Drive Plans and Technologies to Secure the Grid. Winter 2015. From: http://www.epri.com/abstracts/Pages/ProductAbstract.aspx?ProductId=000000003002004850

ASTM E948-09. Standard Test Method for Electrical Performance of Photovoltaic Cells Using Reference Cells Under Simulated Sunlight.

NATIONAL INSTRUMENTS, USB-6009

Dispositivo DAQ Multifunción de Bajo Costo de 14 Bits, 48 kS/s. Disponible en: http://sine.ni.com/nips/cds/view/p/lang/es/nid/2

[consultado el 21 de agosto de 2015].

Jiménez K, Londoño C, Restrepo S, Valencia J, Velilla E. Obtención de los parámetros del modelo de un diodo para la modelación de paneles solares utilizando el Método de Nelder-Mead. Revista Asociación de Ingenieros Electricistas de la UdeA, AIE. Septiembre de 2015.

Cristaldi L, Faifer M, Rossi M, Ponci F. A Simple Photovoltaic Panel Model: CharacterizationProcedure and Evaluation of the Role of Environmental Measurements. IEEE transactions on instrumentation and measurement, vol. 61, no. 10, 2012.

D.T. Cotfas, P.A. Cotfas, S. Kaplanis “Methods to determine the dc parameters of solar cells: A critical review”. Renewable and Sustainable Energy Reviews28 (2013) 588–596.

AMPROBE, Amprobe SOLAR-600 Solar Power Analyzer. Disponible en: http://www.amprobe.com/amprobe/usen/Environmental-Test/Solar-Meters-and-Analyzers-/AMP-SOLAR-600.htm?PID=73346 [consultado el 21 de agosto de 2015].

AMPROBE, Amprobe SOLAR-100 Solar Power Meter. Disponible en: http://www.amprobe.com/amprobe/usen/environmental-testers/solar-meters-and-analyzers-/amp-solar-100.htm?pid=73342# [consultado el 21 de agosto de 2015].

Published

2015-12-20

How to Cite

Cano, J. B., Valencia, J., Jaramillo, F., & Velilla, E. (2015). Development and implementation of an electronic prototype for solar panel characterization on exterior conditions. Revista Politécnica, 11(21), 41–50. Retrieved from https://revistas.elpoli.edu.co/index.php/pol/article/view/618

Issue

Section

Articles

Most read articles by the same author(s)

Similar Articles

<< < 

You may also start an advanced similarity search for this article.